next up previous contents index
Next: SET CHECK Up: SET Previous: SET BOX   Contents   Index


        LAS\SET CALIBRATION [Beam_Tol [Gain_Tol]] or OFF

    Specify the tolerance on the Beam efficiency (Beam_Tol) and  gain  image
    ratio (Gain_Tol), on turn or calibration checking. A value of 0 means no
    check. The default values are 0.02 and 0 respectively.

    These values are used by the command CONSISTENCY (and the other commands
    using it implicitely) to verify that the calibration is consistant. They
    are also used by command WRITE which writes the  corresponding  informa-
    tion  in the output file only if Beam_Tol is non zero. Note that because
    the beam efficiency is less than 1, you could use Beam_Tol=1 to suppress
    the calibration checking but still write the information.

Gildas manager 2020-04-07