next up previous contents index
Next: SET MODE Up: SET Previous: SET MAP   Contents   Index


SET MATCH

        LAS\SET MATCH [Tolerance [Unit]]

    Turn on the checking of position-matching in CONSISTENCY (and the  other
    commands  using  it). This tolerance is also used in FIND, MAP and a few
    other commands.

    The Tolerance is the offset position tolerance expressed  in  the  given
    unit  if  any (RAD, DEG, MIN, SEC, MAS), or current Class unit if absent
    (current SET ANGLE). If the Tolerance is absent, it resets  to  its  de-
    fault (2 arc seconds).


Gildas manager 2018-02-18