next up previous contents index
Next: SET APC Up: SET Previous: SET ANGLE   Contents   Index


        CLIC\SET ANTENNAS [a1 a2 ...]

    Selects the antennas for which data will be displayed by  command  PLOT.
    This command is exclusive with commands SET BASELINES and SET TRIANGLES.

    Parameters which may be displayed in this antenna-mode are  obvious  an-
    tenna-based parameters such as cable phase, LO-phase and rate, ...  With
    SET Y AMPLITUDE and when more than 3 antennas are available in the data,
    antenna  amplitude is computed by averaging all possible "triangular ra-
    tios" of baseline amplitudes. With SET Y PHASE a phase is attributed  to
    each  antenna  by setting the phase of antenna 1 to zero, and making use
    of closure relations for other antennas (least square fit). This is use-
    ful  for fitting baselines for instance (it enables one to determine di-
    rectly antenna position offsets).

    SET ANTENNA with no arguments selects all antennas present in the  base-
    lines  previously  in  use. SET ANTENNA ALL will select all the antennas
    available in the first scan of the current index, for each  command  ac-
    cessing the data (e.g. PLOT).  This is the default.

    Note  that SET ANTENNA also allows to select the antenna to be processed
    by the SOLVE HOLOGRAPHY command (if several antennas are  selected,  the
    first one in the list is processed).

Gildas manager 2019-02-19