Next: SET MODE
Up: SET
Previous: SET MAP
Contents
Index
SET MATCH
LAS\SET MATCH [Tolerance [Unit]]
Turn on the checking of position-matching in CONSISTENCY (and the other
commands using it). This tolerance is also used in FIND, MAP and a few
other commands.
The Tolerance is the offset position tolerance expressed in the given
unit if any (RAD, DEG, MIN, SEC, MAS), or current Class unit if absent
(current SET ANGLE). If the Tolerance is absent, it resets to its de-
fault (2 arc seconds).
Gildas manager
2024-04-18