PRINT FIT

        ANALYSE\PRINT FIT

    The information written is the following ("current angle  unit"  is  the
    current SET ANGLE setting):
      - 1 Number of lines fitted,
      - 2 Observation number,
      - 3 Lambda offset [current angle unit],
      - 4 Beta offset [current angle unit],

    Then  follows  the  fit  results for the current selected method (METHOD
    command), in the same order as in DISPLAY command. "X"  means  SET  UNIT
    unit at time of the fit.

    METHOD GAUSS:
      -  5 Fitted line area [K.X],
      -  6 Error on fitted line area [K.X],
      -  7 Fitted position [X],
      -  8 Error on fitted position [X],
      -  9 Fitted width [X],
      - 10 Error on fitted width [X],
      - 11 Intensity (Area/Width/1.064467) [K],
      - 12 Base RMS [K],
      - 13 Line RMS [K]

    METHOD CONTINUUM:
      -  1 Observation number,
      -  2 Azimuth [degrees],
      -  3 Elevation [degrees],
      -  4 Fitted line area [counts.current angle unit],
      -  5 Error on fitted line area [counts.current angle unit],
      -  6 Fitted position [current angle unit],
      -  7 Error on fitted position [current angle unit],
      -  8 Fitted width [current angle unit],
      -  9 Error on fitted width [current angle unit],
      - 10 Fitted intensity (Area/Width/1.064467) [counts],
      - 11 Base RMS [counts],
      - 12 Line RMS [counts],
      - 13 Source name