VARIABLES

 

        CLIC\VARIABLES group state

    This command is used to enable/disable CLIC variables.  'state'  may  be
    ON   or   OFF;   12  groups of variables are available, corresponding to
    sections in the scan headers.
  READ_WRITE     Input/Output file information (Global)
  GENERAL        General information (Scan based)
  POSITION       Source related information (Scan based)
  CONFIG         Array configuration related information (Scan based)
  RF_SETUP       Receiver related information (Scan based)
  CONTINUUM      Continuum correlator related information (Scan based)
  LINE           Spectral correlator related information (Scan based)
  SCANNING       Special scan information (Record based)
  ATMOSPHERE     Atmospheric calibration parameters and results (Scan based)
  DESCRIPTOR     Data descriptor information (Scan based)
  DATA_HEADER    Data header information (Record based)
  DATA_RECORD    Data values (Record based)

    Scan or Record based variables variables refer to the last read scan  or
    record  (explicitely  by  GET/RECORD,  or  implicitely  by PLOT or other
    commands).

• VARIABLES READ_WRITE
• VARIABLES GENERAL
• VARIABLES POSITION
• VARIABLES CONFIG
• VARIABLES RF_SETUP
• VARIABLES CONTINUUM
• VARIABLES LINE
• VARIABLES SCANNING
• VARIABLES ATMOSPHERE
• VARIABLES DESCRIPTOR
• VARIABLES DATA_HEADER
• VARIABLES DATA_RECORD