SHOW

                  OBS\SHOW [* | Item]

       OBS\SHOW      : Refreshes the "full-screen" display
       OBS\SHOW *    : Lists all parameter values.
       OBS\SHOW item : List one parameter.

    The available parameters are
       ANGLE       D|M|S                 : Angle unit type
       AMBIANT     Tamb Pamb | AUTO      : Meteo parameters and mode
       ARRAY       List                  : Antennas in array
       ATMOSPHERE  T_atm_s T_atm_i       : Atmospheric temperature (*)
       ATTENUATION Att_1  Att_2          : Attenuation for calibration
       BEAM_THROW  Value                 : Chopper throw (*)
       CALIBRATION AUTO|MANUAL|NONE|TREC : Calibration mode (*)
       CHOPPER     T_warm T_cold         : Chopper temperatures (*)
       CORRECTIONS -COH -COV HFO0        : Pointing and focus corrections (*)
       DEBUG       On | Off              : Debug flags (for test only)
       FORWARD     F_eff                 : Forward (=Beam) efficiencies (*)
       FIT         On | Off              : Fit pointing scans ?
       GAIN_IMAGE  G                     : Gain/Signal band ratio (*)
       LEVEL       terminal file         : message priority level
       MODE                              : OBS operating mode
       OFFSETS     Basis | Horizon       : Offsets type
       OPACITY     Tau_S Tau_I           : Atmospheric opacities (*)
       PHASE       Atm | Noatm | Both    : Atmospheric phase compensation
       SCAN        Ns                    : Number of scans per START
       SUBSCAN     Ns                    : Number of subscan per scan
       TABLE       Sky                   : Table OFF position
       TREC        Trec Tsys             : Receiver and System temperature (*)
       WATER       wH2O                  : Water vapor content  (*)

    Parameters marked (*) may depend on antenna.  All antennas are listed in
    this case.